UL 61010-2-032 PDF

1 Scope and object

IEC 61010-1:2010, Clause 1 and IEC 61010-1:2010/AMD1:2016, Clause 1 apply except as follows:

Replace the existing text with the following:

This document specifies safety requirements for hand-held and hand-manipulated current sensors intended for measuring, detecting or injecting current, or indicating current waveforms on circuits without physically opening the current path of the circuit being measured.

These current sensors are hand-manipulated before and/or after a test or measurement, but are not necessarily hand-held during the test or measurement. They can be stand-alone current sensors or accessories to other equipment or parts of combined equipment. These include measurement circuits which are part of electrical test and measurement equipment, laboratory equipment, or process control equipment.

NOTE 1 Combined equipment is equipment that is electrically connected to a current sensor by means of a permanent connection which can be detached only by the use of a tool.

NOTE 2 Some current sensors are also known as current clamps, clamp multimeters and current probes.

The types of current sensors covered by this document are defined in Annex FF.

Summary of Topics

This new Third Edition of ANSI/UL 61010-2-032 dated October 17, 2024 is an Adoption of IEC 61010-2-032, Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory Use – Part 2-032: Particular Requirements for Hand-Held and Hand-Manipulated Current Sensors for Electrical Test and Measurement (fifth edition, issued by IEC September 2023) as a new IEC-based UL standard with US National Differences.